Mylands polish

Whats the best way to apply Mylands polish?

Good question!
I use Mylands on most of my turnings. I use a three part finish.

I apply the finish with old bed sheets that have been cut into 6" x 6" squares and folded to be comfortable in my hand. I use a different corner for each application below and a new square for each step.

First step - I apply three coats of Mylands Sander Sealer. The first coat is rubbed in very well (with the lathe off) and then rubbed in with the Lathe turned on and friction applied to build the finish. The final two layers are rubbed in while the lathe is running. Use only as small amount as needed to cover the piece for each layer (usually only a few drops). This is were you are building the base for the layers to follow. If you need to, you can even sand between layers to fill in all you "punky" areas.

Second step - I apply three coats of High Friction Polish. Again the first layer is applied with the lathe off and then rubbed inn to build the finish. Again the final two layers are applied with the lathe turned on and rubbed in to build the finish. And again, use only the amount of polish needed to cover the piece. This is were you really build the finish, dont be affraid to build some good heat to "flow" the finish.

Third step - I apply Carnuba Bar Wax. I usually apply all three layers with the lathe turned on. on this blayer be careful not "burn" (get the wax too hot) each layer too much. This is were polish the finish to the gloss you are looking for.

I have also used a buffing wheel between each layer of the second and third steps to give a very smooth finish.

Mylands provides a natural feel to the wood, with a not too glossy finish.

If you have any questions, post here or find me at the meetings.

Troy

Thanks Troy, big help